Kids Crafts

Materials needed:

• Kreinik 1/8" Ribbon in 052F, 053F, 092
• Kreinik #32 Braid 080HL, 339, 008
• Wood turnings from a craft store, 1" to 1 1/2" high (for this project Wood Shoppe Turnings by Crafts, Etc were used #165563 Boy, #065555 Girl, and #371831 Bumble Bee)
• Small oval wooden box (unfinished) or small oval paper mache box
• Treasure Tape, 1-inch roll, and 1/4-inch roll
• Fine Point Permanent markers for facial features (we used red, brown, blue and green)
• Scissors

Instructions:

• To make clothing on the worry dolls, begin at the neckline and lay a thin line of 1/4” Treasure Tape around the woodturning. Peel off the red liner and lay braid or ribbon of your choice around the neckline by wrapping it and lightly pressing it onto the tape. Change colors of thread to make stripes. Continue wrapping to the bottom of the wood turning.
• Lay pieces of Treasure Tape on the top of each ‘head’. Remove red liner to expose the sticky part. Cut lengths of braid or ribbon for hair and lay on the taped head. For the boy and baby, cut lengths approximately 1-inch. For the girl, cut lengths 4 inches long. For the girl, pull strands together near the side of her face and tie with 1/8” Ribbon to make pony tails.
• Use fine point permanent markers to draw eyes and mouth on dolls.
• To decorate the box, begin at the bottom edge, and lay the larger roll of Treasure Tape all the way around the box. Do not put tape around the top of the box where the lid will hang over. Remove the red liner to expose sticky tape. Lay braid and ribbon around sides of box in stripes, covering the tape.
• For the lid, lay Treasure Tape to cover the whole lid. Remove red liner to expose sticky tape. Decorate with the braid and ribbon. Do the same around the side of the lid.

NOTE: This item is not shipped. 

Designed By eXpresSew

No one wants to fade away when the sun goes down. Keep your “glow” when the lights go out by decorating this plain t-shirt with fluorescent flowers.  

Get everything together:

• Plain t-shirt in white or other solid color 
• Glow-in-the-Dark thread by Kreinik, 1/8” ribbon or #32 Braid weight – 2 colors that look good together. You’ll need 1 spool of each color. 
• Sewing thread that matches the t-shirt 
• Disappearing pencil that can be seen on your t-shirt and erased later 
• Ruler 
• Sewing machine 
• Embroidery hand sewing needle with large eye 
• Small piece of paste board or tag board (like from a cereal box) – about 2” wide and 3” long 
• Iron with steam setting
• Ironing board

Instructions:

Place the t-shirt flat on a table with the front facing up. Draw a line straight across the chest from sleeve to sleeve. Draw 2 more lines each _” apart. (Diag. 1). 

Set up your sewing machine with the matching thread. Starting at one sleeve seam, lay one color thread over the top line and zigzag it to the shirt. (Diag. 2). Try NOT to stretch the shirt as you sew.Leave a thread tail at both ends of the line about 3” long.(By the way, zigzagging over a thick thread is called “couching”.) Zigzag or couch over the middle line with the second color thread. Couch the last line with the first color thread. 

Push the embroidery needle through the shirt where the line meets the sleeve seam. Thread the tail through the large eye in the needle and pull the tail end through to the inside of the shirt. (Diag. 3). Repeat for the tails at each line end. Turn the shirt wrong side out. Stitch the tails back and forth securely to the seam allowance at each sleeve. Trim the tails off. 

Print the pattern guide and use it to cut a template from the tag board for making the flowers. 

For flowers, cut one piece of Glow-in-the-Dark thread about 6” long and keep it handy to tie the middle of the flower. Next wrap the thread around the template 8 full times and cut it off. (Diag. 4). Slide the tie piece through the space in the template and tie around the thread very tightly. (Diag. 5). Tie again and knot. Slide the flower off the template and cut the top and bottom loops. Trim the ends evenly. Make three flowers with the first color and two flowers with the second color. 

Place the flowers on the ironing board and set the iron to the lowest setting for steam. Fan the threads out and press lightly with the iron until your flowers have a nice rounded shape. 

Handstitch the flowers onto the middle line, alternating colors from left to right.   

• lip gloss container tube (it helps to have one with a flat, squared lid)
• Treasure Tape 1-inch roll
• Diamond Beadlets
• Flat-backed sequins or beads
• Kreinik 1/16” Ribbon in 273 Red orange or a color to match your gloss

Instructions:

1. Make sure the lid of your lip gloss is clean and smooth.
2. Wrap lid with Treasure Tape roll.
3. Remove the red liner to expose sticky tape.
4. Lay flat-backed sequins or buttons on this tape as desired.
5. Lay your 1/16” Ribbon around each sequin, or in any decorative way.
6. Put your tube in a shallow tray and cover with Diamond Beadlets. Make sure all remaining sticky areas are covered with beads.

1. Cover entire top of the tin box with the 1-inch Treasure Tape.
2. Peel back red liner to expose sticky part, and place cabochons randomly on the lid.
3. Using the colors of #12 Braid, decorate tin lid with thread. Follow the photograph as a guide, or make your own pattern.
4. Lay the lid in a shallow pan or tray, cover the sticky areas with Diamond Beadlets®.
5. Put lid back onto your container.
6. In the space below the lid and the bottom of the tin, wrap 1/4” Treasure Tape around, using more than one strip if needed to fill in the space with the tape.
7. Remove red liner to expose sticky tape, and lay your decorative ribbon on the tape, pressing to make sure it sticks well. Tie ends into a bow.
    

• Kreinik small Bag O'Bits
• Flat-backed flower buttons
• Diamond Beadlets®
• 1-inch roll of Treasure Tape™ 
• 4” x 6” or smaller photo
• purchased purse with flat area on which you can put a photo (such as a pocket, or flat front)
• shallow tray or pan

Instructions:

1. Cover the back of your photo with strips of the 1-inch Treasure Tape. Leave the red liner on it for now.
2. Cover the top of the photo with strips of the 1-inch Treasure Tape. Remove the red liner to expose the top sticky area. 
3. On the sticky area, decorate with the metallic thread from the Bag O' Bits as desired.
4. Add buttons or other flat-back cabochons as desired.
5. Trim your photo down to the desired size
6. When embellishing is complete, lay your photo in the shallow tray and cover with Diamond Beadlets, swirling with your fingers to make sure all sticky areas are covered.
7. Remove the red liner from the tape on the back of your photo to expose the sticky area. Position it on the desired location on your purse and press firmly, making sure it adheres completely.
    

Note: this item is not shipped

Time for summer camp!

Summer is a great time to craft with your kids. They’ve got the energy, interest, and time. Here are a few ideas for adding a creative and homemade touch to camp this year. Decorate with beads, tape and thread, and you’ll have as much fun as your kids!

Materials needed:

• Kreinik Large Bag O'Bits
• 1-inch roll Red-liner Treasure Tape
• tube of Diamond Beadlets

Gear up before camp

Before they go to camp, the kids can decorate and personalize their basic gear (alarm clocks, hairbrushes, backpacks even lip gloss and small tin containers). Decorate these items with red-liner double-sided tape, threads and beads — everyone will know who owns the colorful gear. Have your child pick a favorite color thread (like purple), and decorate all of their camp stuff with that thread.

Make a “Care Package” for your child

Get a cool organizer and fill it with a variety of projects, from bunk activities to birthday party crafts (for those away during their birthdays) to stationery kits.

Memory crafts after camp

With all the pictures taken at camp, build a fun project for your child around the whole theme of “Memories.”  Buy an unfinished wooden frame at a discount or craft store, then embellish it using the same technique: cover with Treasure Tape, then decorate with beads, flowers, threads, buttons and more. Your child may want to make a frame for each friend or counselor from camp. What a special gift!  

Note: this item is not shipped

Designed by Brenda Spitzer

• Kreinik 1/8” Ribbon 055F and 052F
• letter beads for your name
• two #3 embroidery needles
• scissors
• tape measure
• masking tape

1. To make a 6-inch bracelet, cut a 72-inch length of 055F Ribbon. This will be your knotting cord. Cut a 36-inch length of 052F Braid. This will be your filler cord. Fold both cords in half. Place folded ends together and tie an overhand knot 1/2-inch from end. (See diagrams A and B)
2. Place knotted end of cords on a flat surface like a table. Tape the knot to the surface with masking tape. Make sure that knotting cords lay on the outside and filler cords on the inside.
3. Tie a series of square knots to measure 2 inches in length. (See diagram for square knot. Bring knotting cord on left across filler cords and under right knotting cord as in “C”. Then bring right knotting cord under filler cords and then through and over the loop made by left knotting cord. Now grasp the end of knotting cord that is on the left. Bring this cord under the filler cords. Grasp the end of knotting cord that is on the right. Bring it over the filler cords. Bring knotting cords through loops on both sides, pull snuggly.)
4. Thread the two center, filler cords through the needles. Add the bead for the first letter of your name to the two filler cords by threading the needles and cords through the hole of the bead. Tie two more square knots and add the next letter of your name. Repeat this process for all the letters in your name.
5. After all of the letter beads have been added, tie another series of square knots measuring two inches in length. (Note: depending on the number of letters in your name, you may want to make the series of square knots before and after your name, either longer or shorter than two inches. The overall length of the bracelet should be the same as the measurement of your own wrist.)
6. To finish the bracelet, tie the cords into three overhand knots. Trim the ends of the cord. To fasten the bracelet, push the ending knot through the beginning loop.

Little Girls' Pet Purse

Beaded Dog Album

Button Frame designed by Treasure It

All American Tin designed by Treasure It

Turn your child's crayon artwork into fiber artwork